User Guide

ArduCAM USB3 Camera Shield User Guide
Table 1 8-bit Camera Interface Pin Definition
(Connector Part Number: Hirose FH28D-30S-0.5SH(05))
Pin No. PIN NAME TYPE DESCRIPTION
1 GND Ground Power ground
2 Reserved NC
3 Reserved NC
4 VSYNC Input Active High: Frame Valid; indicates active frame
5 HREF Input Active High: Line/Data Valid; indicates active pixels
6 DOUT11 Input Camera Pixel Data Input 11 (MSB)
7 DOUT10 Input Camera Pixel Data Input 10
8 DOUT9 Input Camera Pixel Data Input 9
9 DOUT8 Input Camera Pixel Data Input 8
10 DOUT7 Input Camera Pixel Data Input 7
11 DOUT6 Input Camera Pixel Data Input 6
12 DOUT5 Input Camera Pixel Data Input 5
13 GND Ground Power ground
14 DOUT4 Input Camera Pixel Data Input 4 (LSB)
15 DOUT3 Input Camera Pixel Data Input 3 (Unconnected)
16 DOUT2 Input Camera Pixel Data Input 2 (Unconnected)
17 DOUT1 Input Camera Pixel Data Input 1 (Unconnected)
18 DOUT0 Input Camera Pixel Data Input 0 (Unconnected)
19 Reserved NC
20 PCLK Input Pixel Clock output from Camera
21 SCL Output Two-Wire Serial Interface Clock
22 SDATA Bi-directional Two-Wire Serial Interface Data I/O
23 RST Output Sensor reset signal, active low
24 GND Ground Power ground
25 GND Ground Power ground
26 STANDBY Output Standby-mode enable pin (active HIGH)
27~30 VCC POWER 3.3v Power supply
2.2 16-bit Camera Interface
The secondary camera interface is used for MIPI camera, stereo-camera or customized
camera adapter boards which support up to 16bit data bus. The pin definition is shown in Table 2.
www.ArduCAM.com
3