Data Sheet

Synchronized Stereo CAMERA HAT
www.ArduCAM.com
4
Figure 3 8MP V2 Pi Camera Rework Instruction
For 5MP V1.3 Pi Camera
Removing the oscillator IC marked in circle from one of the camera board, and using
jumping wires soldered to the pads as shown in the Figure 4, twist the jumping wires will improve
the signal quality.
Figure 4 5MP V1.3 Pi Camera Rework Instruction
4.2 Step 2
Attach the 22pin-15pin ribbon cable to the stereo camera HAT (22pin end) and Raspberry Pi
CSI port (15pin end).
Figure 5 Connect the 15pin-22pin ribbon cable