User Manual

User’s manual – AREBOS Bench drill 500W
5
• Connect it to a vacuum cleaner. If there are connections for dust extraction and collection,
make sure that they are connected and used correctly.
• Do not use the cable for purposes for which it is not intended. Do not use the cable to
disconnect the plug from the outlet. Protect the cable from heat, oil, and sharp edges.
• Secure the workpiece. Use clamping devices or a vice to hold the workpiece. It is therefore
held more securely than with your hand.
• Avoid abnormal posture. Ensure a secure stand and maintain balance at all times.
• Maintain your tools with care. Keep the cutting tools sharp and clean to work better and
safer. Follow the lubrication and tool change instructions. Check the connection wiring of the
power tool regularly and have it replaced by an approved specialist if damaged. Check
extension cords regularly and replace them if damaged. Keep handles dry, clean and free of
oil and grease.
• Disconnect the plug from the socket. When not using the power tool, before maintenance
and when changing tools such as saw blade, drill bit, milling cutter.
• Do not leave any tool keys inserted. Before switching on, check that the keys and setting
tools have been removed.
• Avoid unintentional start-up. Make sure that the switch is turned off when the plug is
plugged into the socket.
• Use an extension cord for outdoor use. In the open air, only use extension cables approved
for this purpose and marked accordingly.
• Be careful. Pay attention to what you are doing. Get to work with common sense. Do not use
the electrical tool if you are not concentrated.
• Check the power tool for possible damage. Before continuing to use the power tool, carefully
inspect protective devices or slightly damaged parts to ensure that they are functioning
properly and in accordance with their intended purpose. Check that the moving parts
function properly and are not jammed or that parts are damaged. All parts must be properly
assembled and meet all conditions to ensure proper operation of the power tool. Damaged
safety devices and parts must be repaired or replaced by a recognised specialist workshop in
accordance with their intended use, unless otherwise specified in the instructions for use.
Damaged switches must be replaced at a customer service workshop. Do not use power tools
if the switch cannot be switched on and off.
• Caution! The use of other tools and accessories may result in injury.
• Have your power tool repaired by a qualified electrician. This power tool complies with the
relevant safety regulations. Repairs may only be carried out by a qualified electrician using
original spare parts.
• Never obscure warning labels on the power tool.
• Mount the power tool on a firm, level and horizontal surface. If the power tool can slip or
wobble, the insertion tool cannot be guided evenly and safely.
• Keep the work surface clean except for the workpiece to be machined. Sharp-edged drilling
chips and objects can lead to injuries. Material mixtures are especially dangerous. Light metal
dust can burn or explode.
• Guide the insert tool only switched on against the workpiece. Otherwise there is a risk that
the insert tool will get caught in the workpiece and the workpiece will be taken with it. This
can lead to injuries.
• Do not enter the drilling area with your hands while the power tool is running. There is a risk
of injury if you come into contact with the insert tool.
• Never remove drill chips from the drilling area while the power tool is running. Always move
the drive unit first to the rest position and switch off the power tool.
• Do not remove any drilling chips with bare hands. Hot and sharp-edged metal chips in
particular pose a risk of injury.