User Manual

User’s Manual – AREBOS Nibbler machine 625 W
3
surfaces. For example: pipes, radiators, ranges, refrigerator enclosures.
• Keep children and third parties away from work area.
• Store unused tools. When not in use, tools should be stored in dry and high or locked-up
place out of reach for children.
• Do not overload the machine! To ensure an optimum in the performance and safety of the
device, only use within the set parameters.
• Use only suitable tools. Don’t use small tools or attachments. Don’t use tool for not intended
purposes. For example: don’t use circular saw for cutting tree limbs or logs.
• Dress properly. Do not wear loose clothing or jewellery. They can get caught in moving parts.
Rubber gloves and non-skid footwear are recommended when working outdoors. Wear
protective hair covering to contain long hair.
• Use safety glasses. Also use face or dust mask if cutting operation is dusty.
• Do not damage the connection cable. Never carry tool by cord or yank it to disconnect from
the plug. Keep cord from heat and oil sources and sharp edges.
• Secure work area. It is recommended to use clamps or a vice for fixation. Please pay special
attention to your hands when operating the device!
• Do not overreach yourself. Keep proper footing and balance at all times.
• Maintain tools with care. Keep tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories. Inspect extension cords
periodically and replace if damaged. Keep handles dry, clean, and free from oil and grease.
• Switch off the device and disconnect the cable before maintenance or changing accessories
e.g. blades, bits, cutters.
• Remove adjusting keys and wrenches. Always make sure that keys and adjusting wrenches
are removed from tool before turning it on.
• Avoid unintentional starting. Don’t carry plugged-in tool with finger on switch. Be sure switch
is off when plugging in.
• During outdoor work use extension cords intended for outdoor use and marked accordingly.
• Stay alert when operating the device. Do not operate tool when you are tired.
• Check damaged parts. Before further use of the tool, any covers or other parts that are
damaged should be carefully checked to determine that it will operate properly and perform
its intended function. Check for alignment of moving parts, mounting, and any other
conditions that may affect its operation. A cover or other part that is damaged should be
properly repaired or replaced by an authorized service centre unless otherwise indicated
elsewhere in this instruction manual. Defective switches should be replaced by an authorized
service centre. Do not use tool if switch does not turn it on and off.
• Do not use power tools for applications other than those specified in the instruction (other
than that for which it was designed).
• To ensure the designed operational integrity of power tools, do not remove installed covers
or screws.
• Do not touch movable parts or accessories unless the power source has been disconnected.
• Use your tool at lower input load than specified on the nameplate to increase working
efficiency and decrease wear out.
• Do not wipe plastic parts with solvent. Solvents such as gasoline, thinner, benzene, alcohol,
ammonia and oil may damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water.
• Consult an authorized service agent in the event of power tool failure.
• Use only original replacement parts.
• This tool should only be disassembled for replacement of carbon brushes.