User Manual

User’s Manual – AREBOS Nibbler machine 625 W
6
cut (do not tilt the device sideways, tilting may reduce efficiency of the device and may
damage the cutting knife). Never exert too much pressure when cutting curved areas. To
improve the service life of the cutting knife and the die, use cutting oils which must be
properly selected according to the processed material. Lubricate the cutting knife and the die
with machine oil. Make sure the knife is always sharp to achieve good cutting quality. Blunt /
worn out knifes should be replaced with new ones. Never sharpen worn out knives.
• Never turn the device off before finishing the work - the cutting head must be removed
from the material while the device is still on. The device may be turned off when the
cutting head is removed from the processed material.
Replacing the upper and lower knife guides
• Loosen the fastening screws (4) of the upper (1) and lower (3) guides, then remove the
guides. Clean surfaces. Fasten new guides.
Replacing the cutting knife
• Use the key provided to loosen the screw fastening the piston sleeve (6). Remove the piston
sleeve (5), disassemble worn out knife and assemble a new one. Lubricate the knife and
piston connection point with grease.
Maintenance and inspection
• Inspecting the tool
Since use of a dull tool will cause motor malfunctioning, it should be replaced with a new one
without delay when abrasion is noticed.
• Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened. Should
any of the screws be loose, retighten them immediately. Failure to do so could result in
serious hazards.
• Maintenance of the motor
The rotor of the motor is the very “heart” of the power tool. Exercise due care to ensure the
rotor does not become damaged and/or wet with oil or water.
Always de-energise the device before inspection or servicing
• Keep the device clean, pay particular attention to making sure that the vents are not clogged.
Clean vents after every operation of the device.
• Service
When servicing, use only identical replacement parts. In such case please contact our service
centre. Use of any other part may create a hazard or cause product damage.
Do not attempt to modify tools or create accessories not recommended. Any such alteration
or modification is misuse and could result in a hazardous condition leading to possible
serious injury. It will also void the warranty.
Regular control of the device
• Regularly control that the device doesn´t present any damage. If there is any damage, please
stop using the device. Please contact your customer service to solve the problem.
• What to do in case of a problem?
Please contact your customer service and prepare following information:
- Invoice number and serial number (the latter is to be found on the technical plate on the
device).
- If relevant, a picture of the damaged, broken or defective part.
- It will be easier for your customer service clerk to determine the source of the problem if
you give a detailed and precise description of the matter. The more detailed your
information, the better the customer service will be able to solve your problem rapidly