User Manual

User’s Manual – AREBOS Concrete Vibrator 580/800 W
6
2. Operation
1. Locking nut
2. Flexible shaft
3. Joint shaft
4. Trigger switch
5. Switch button
2.1 Steps
1. Insert the joint shaft (3) into the hole of the flexible shaft (2), turn the locking nut (1)
counterclockwise to fix the vibrator.
2. Press the trigger switch (4) to start the motor. For continuous operation press the switch
button (5) while the trigger switch (4) is pressed. In order to switch off the motor during the
continuous operation press the trigger switch (4) again.
3. If the vibrator does not start vibration after the start of the motor, it should be knocked.
Then the vibrator can be used.
4. The motor should be mounted on a scaffold or placed on a hard surface during operation.
Never place it on the concrete which has not yet set to us. A wooden plate with dimensions
more than 11.81 x 11.81 in (30 x 30 cm) can be placed on the unconsolidated concrete for
the need of construction site. Then the motor is put on the wooden plate and fixed in order
to avoid the damage of the motor when it is stuck in the unconsolidated concrete.
ATTENTION: The locking nut is hot when running, do not touch!
2.2 Applications
• The distance between two compaction points and the duration of compaction work depends
on the thickness of the concrete layer and the composition of the concrete.
The following points serve as an indication.
2.3 Flooring
1. Slowly insert the vibrating hose into the concrete. (Compression time about 3-4 seconds).
2. Slowly pull the vibrating hose out of the concrete and repeat the process every 19.7 in (50
cm).
2.4 Walls and columns
1. Fill with concrete up to the height of about 39.4 in (100 cm).
2. Insert the internal vibrator into the formwork.
3. Slowly pull the vibrating hose out of the concrete and change it to the next position.
4. Now the next concrete filling of about 39.4 in (100 cm) height can be done.