User Manual

User’s Manual – AREBOS Concrete Vibrator 580/800 W
7
3. Technical specifications
Model
AR-HE-BR58015
AR-HE-BR80015
AR-HE-BR80020
Machine
Input Power
580 W
800 W
800 W
Rated input voltage
230 V
230 V
230 V
Frequency
50 Hz
50 Hz
50 Hz
Material
Plastic
Plastic
Plastic
Rotation speed
4000 rpm
5600 rpm
5600 rpm
Shaft
Ø vibrating head
1.38 in (35 mm)
1.38 in (35 mm)
1.38 in (35 mm)
Ø rubber hose
1.18 in (30 mm)
1.18 in (30 mm)
1.18 in (30 mm)
Ø flexible shaft
0.394 in (10 mm)
0.394 in (10 mm)
0.394 in (10 mm)
Length
1.5 m
1.5 m
2 m
4. Cleaning and maintenance
• When it is operated, the motor should be cleaned outside if necessary. Especially the inlet
and outlet of the motor must always be kept clear.
• When it is operated, check if all the connecting screws are tighten. The place where the
vibrator connects to the motor should be cleaned up, and fed some drops of oil, and then the
connector of the vibrator is covered with a protective cover.
• During operation, check the wear of carbon brush. If it is necessary it should be replaced to
avoid the damage of the motor. The carbon brush can be replaced only by technically
qualified personnel.
• The brushes should be checked periodically and worn-out brushes should be replaced in
time, after replacing inspect whether the new brushes can move freely in the brush holder -
keep running the motor for 15 minutes to match the contact of brushes and commutator.
• Keep the ventilation slots clean, remove the accumulated dust and oil dirt periodically.
• If something happens during normal operation the power supply should be switched off
immediately and the tool should be checked and repaired.
• Regularly inspect all mounting screws and ensure that they are properly tightened. If any of
the screws are loose tighten them immediately, failure to do so could result in personal
injury.
• Do not expose the tool in rainy, damp or wet conditions, keep work area well lit, do not use
power tools where there is risk of fire or explosion.
• Ensure your power tool is serviced by qualified personnel using only identical replacement
parts. This will ensure the safety operation of the power tool.