User Manual

User’s manual – AREBOS Demolition Hammer 1700W
10
• Pull out the locking bolt (4) again, turn it through 180° in the opposite direction and release
it.
• Check the lock by pulling the tool.
Remove/replace the tool
• Proceed in reverse order to mounting.
• WARNING: Accessories can be hot after use. Don’t touch the tip of accessory by hand! Please
always use protective gloves to remove the accessory.
Additional handle
• For safety reasons you must only use the demolition hammer with the additional handle.
• The additional handle (2) enables you to achieve better stability while using the demolition
hammer.
• The additional handle can be turned into any required position. To do so, undo the lock knob
(8) of auxiliary handle. Then turn the handle into the most comfortable working position and
tighten the lock knob (8) again.
• Important: To avoid danger, the machine must only be held using the two handles (2-3).
Otherwise you may suffer an electric shock if you chisel into cables.
How to replace grease
Check the grease level before using the machine (every 1/3 month is recommended).
• Place the machine on the floor with the tool chuck (5), pointing downwards.
• The grease must be at least 3 mm above the bottom of the inspection window (6).
The grease should be changed after around 40-50 hours of use.
Recommended filling amount: 25g of grease.
Grease replacement
• Switch off the machine and disconnect the plug from the socket.
• Undo the hexagonal head screw with the inspection window (6) using the wrench (7) and
wipe off the old grease inside.
• Add new grease (approx. 25g) through the filler opening until the level reaches the required
level. Tighten the hexagonal screw again.
Maintenance
• Check every day the tightening of screws and nuts. Except the procedures described in this
manual, this tool needs no specific maintenance. The repair of the tool's inner components is
of the competence of specialists. The cleaning of plastic parts is done with a soft damp cloth
and a bit of mild soap. Never submerge the tool and do not use detergents, alcohol, spirit,
etc... For an in-depth cleaning, please consult the after-sales department.
• WARNING: For maintenance and cleaning, always remove the plug from the electric power
supply. Never use water or other liquids to clean electric parts.