User`s manual

APPENDIX
64
Help Command
This –h or –help command provides an on-line table of contents,
providing brief descriptions of the help sub-commands that the
oashash utility recognizes.
The command syntax for the oash-h or -help command is as
follows:
\> oash–h or -help --- display the oashash utility sub-command
option.
The below example shows that oashash utility oash-h or –help
command gets detail information about its sub-command.
-
C:\>oash
======================================
= Copyright (c) 2009 Areca, Inc. All rights reserved. =
= Areca SAS Host Adapter Flash Utility, Version: 1.04 =
======================================
command: oash[options]
/c ctlr# -- assign controller number, default 0
/r lename -- read, backup binary into lename from ash
/w lename -- write, write binary into ash from lename
/l -- list, list all adapters found
Example:
Write ash from le i13_1320.bin into adapter#0
command: oash/ /c 0 /w i13_1320.bin [Enter]
c:\>_
/l Command
This /l command uses to display the oash-supported SAS host
adapter installed on your computer. Use this command to see which
SAS host adapters are installed, and to identify the ID numbers
assigned to each physical host adapter.
The command syntax for the /l command is as follows:
\> oash/l --- list all SAS host adapters found.
This example shows a typical system response to a /l command:
C:\> oash/l