Specifications

Page51of59|ArecontVisionAV200ManualRev1.1


Options\CamerasDisc…Menu(AdministratorOnly)
TheAV200softwarewillscanthenetworkfordiscoveryofnewcamerasonstartup,andwhenmanuallyprompted
by the Re‐discover functionsfound on theHome ribbon bar, and in the Camera List
 Window menu.This menu
allowstheusertoconfigureperiodiccameradiscoveryautomaticallyandtospecifythesoftwarebehaviorwhena
new camera is discovered. Checking the option to Run Automatic Re‐discovery and selecting a time interval in
minuteswilltellthesoftwaretoautomaticallyrunthediscoveryprocess
attheintervalset.Beawarethediscovery
processuses a UDP (UserdatagramProtocol) broadcast and  ifthe interval setis shortmay affecttraffic on busy
networks. The utility of this function can allow automatic discovery of cameras during setup as they are
incrementallyinstalledtothenetwork.
The
 function When New Uninstalled Camera Found determines the software behavior in this instance. If the
PromptforInstallationisset(defaultsetting),thesoftwarewillprompttoaddthecameraandautomaticallyassign
anIPaddresstothecamera.IftheNotifyandSetasBlockedoptionisseta
promptwillnotifytheuserthecamera
wasfoundanditwillbeaddedtothecameralistasblockeduntilRe‐discoverfunctionisrunagain.