Installation Manual
Table Of Contents
- Package Contents
- _Toc480133996
- Camera Overview
- General Installation
- _Toc293149143
- _Toc480133997
- _Toc480133998
- _Toc480133999
- _Toc480134000
- _Toc480134001
- _Toc480134002
- _Toc480134003
- _Toc480134004
- Auxiliary I/O Functions
- _Toc480134005
- _Toc317915403
- _Toc317915404
- Camera Power Up
- _Toc480134006
- Camera Discovery, Setup, and Configuration
- Network Protocols
- _Hlt293570828
- _Toc298421343
- _Toc299264241
- _Toc480134007
- _Toc480134008
- Camera Preset Configurations
- _Toc480134009
- _Toc480134010
- _Toc480134011
- _Toc480134012
- General Remote Focus, Pan, Tilt, Zoom
- _Toc480134013
- AV IP Utility Focus/ Pan/ Tilt/ Zoom Tab
- _Toc397515206
- _Toc480134014
- Mounting Templates
- _Toc480134015
- Support
- _Toc480134016
Installation Manual
Page | 15 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com avsales@arecontvision.com
SurroundVideo® Omni G3
NOTE: When mounting the camera outdoors or in a wet environment, use of the supplied
grommet is required. Ensure the grommet properly seats flush with the camera housing to
create a water-tight seal.
11. Connect the network cable (and the supplied power cable/ I/O cable, if necessary) to the
corresponding connectors inside the camera.
12. Align the holes on main housing cover with the holes on mounting plate, and install the main
housing cover back on to the camera.