Installation Manual
Table Of Contents
- Package Contents
- _Toc480133996
- Camera Overview
- General Installation
- _Toc293149143
- _Toc480133997
- _Toc480133998
- _Toc480133999
- _Toc480134000
- _Toc480134001
- _Toc480134002
- _Toc480134003
- _Toc480134004
- Auxiliary I/O Functions
- _Toc480134005
- _Toc317915403
- _Toc317915404
- Camera Power Up
- _Toc480134006
- Camera Discovery, Setup, and Configuration
- Network Protocols
- _Hlt293570828
- _Toc298421343
- _Toc299264241
- _Toc480134007
- _Toc480134008
- Camera Preset Configurations
- _Toc480134009
- _Toc480134010
- _Toc480134011
- _Toc480134012
- General Remote Focus, Pan, Tilt, Zoom
- _Toc480134013
- AV IP Utility Focus/ Pan/ Tilt/ Zoom Tab
- _Toc397515206
- _Toc480134014
- Mounting Templates
- _Toc480134015
- Support
- _Toc480134016
Installation Manual
Page | 16 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com avsales@arecontvision.com
SurroundVideo® Omni G3
NOTE: If using the side connection of the NPT port, you need to install the supplied grommet
without a through hole on the main housing cover, and remove the cap covering the side
entrance, otherwise; leave the cap in place. If using the NPT port, always use Teflon tape
around the threads to ensure proper sealing. The conduit fits ¾” NPT standard.
13. Use the supplied security L-key to attach the camera to the mounting plate.
14. Swing the camera up into place and use a Phillips head screwdriver to the camera to the
mount plate. Use caution to not bend or pinch the cables during this step.
15. Secure the cover plate as shown in the image below.