Installation Manual
Table Of Contents
- Package Contents
- _Toc480133996
- Camera Overview
- General Installation
- _Toc293149143
- _Toc480133997
- _Toc480133998
- _Toc480133999
- _Toc480134000
- _Toc480134001
- _Toc480134002
- _Toc480134003
- _Toc480134004
- Auxiliary I/O Functions
- _Toc480134005
- _Toc317915403
- _Toc317915404
- Camera Power Up
- _Toc480134006
- Camera Discovery, Setup, and Configuration
- Network Protocols
- _Hlt293570828
- _Toc298421343
- _Toc299264241
- _Toc480134007
- _Toc480134008
- Camera Preset Configurations
- _Toc480134009
- _Toc480134010
- _Toc480134011
- _Toc480134012
- General Remote Focus, Pan, Tilt, Zoom
- _Toc480134013
- AV IP Utility Focus/ Pan/ Tilt/ Zoom Tab
- _Toc397515206
- _Toc480134014
- Mounting Templates
- _Toc480134015
- Support
- _Toc480134016
Installation Manual
Page | 18 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com avsales@arecontvision.com
SurroundVideo® Omni G3
Wall Mounting
For a proper wall mount installation, the AV-WMJB wall mount and SO3-CAP wall mount cap are
required (sold separately).
1. Using the Mounting template, prepare the mounting provisions for the camera installation.
2. Connect SO3-CAP cap and wall mount.
NOTE: The thread size for Top shield, pendant pole and mount is 1.5” NPT.
3. Attach the wall mount to the wall using the four drywall screws provided or any optional
hardware suitable for the mounting surface.
4. Run the Ethernet Cable and outside power cable (if necessary) through the supplied rubber
gasket and then through the wall mount. Ensure the gasket is seated properly.
5. Follow the Step#2 to Stpe#4 from Surface mount installation on P.11 and P.12.
6. If presets will be used for 180°, 270°, or 360° configurations, orient the camera such that the
arrow, denoting the front of the camera, is pointing towards the center of the desired field of
view.
7. Attach the mounting plate to the SO3-CAP with the supplied screws.