Installation Manual

Installation Manual
Page | 25 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
SurroundVideo® Omni G3
Figure 2: Attach corner mount adapter to exterior corner wall
Reference #
Description
1
Attach corner mount adapter to exterior 90 corner wall
2
AV
-
WMJB wall
mount
3
SO3
-
CAP mount cap
5
AV
-
CRMA corner mount adapter
6
Apply Teflon water seal tape to the thread of ¾” NPT
pipe to avoid water leakage
7. Using the screws provided (or other hardware), attach the Corner Mount Adapter to an exterior
90 degree corner wall.
8. To attach the camera to the Wall Mount Adapter (AV-WMJB), reference the Installation and Wall
Mounting section.
9. To configure the camera, reference the camera discovery, set-up and configuration section.
CAUTION! The captive screws must be used to properly secure the dome cover and
camera housing. Failure to use the captive fastener may result in serious injury. When
mounting the dome cover to the camera housing, ensure that the gasket is properly seated
and not folded. Failure to do so may result in water and dust ingress. Water damage from
improper installation is not covered by the warranty!