Installation Manual
Table Of Contents
- Package Contents
- _Toc480133996
- Camera Overview
- General Installation
- _Toc293149143
- _Toc480133997
- _Toc480133998
- _Toc480133999
- _Toc480134000
- _Toc480134001
- _Toc480134002
- _Toc480134003
- _Toc480134004
- Auxiliary I/O Functions
- _Toc480134005
- _Toc317915403
- _Toc317915404
- Camera Power Up
- _Toc480134006
- Camera Discovery, Setup, and Configuration
- Network Protocols
- _Hlt293570828
- _Toc298421343
- _Toc299264241
- _Toc480134007
- _Toc480134008
- Camera Preset Configurations
- _Toc480134009
- _Toc480134010
- _Toc480134011
- _Toc480134012
- General Remote Focus, Pan, Tilt, Zoom
- _Toc480134013
- AV IP Utility Focus/ Pan/ Tilt/ Zoom Tab
- _Toc397515206
- _Toc480134014
- Mounting Templates
- _Toc480134015
- Support
- _Toc480134016
Installation Manual
Page | 27 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com avsales@arecontvision.com
SurroundVideo® Omni G3
Auxiliary I/O Functions
The auxiliary input and output are accessible after removing dome cover as shown in Figure 1.
Figure 1
The output consists of an optically coupled solid state relay (SSR) and the input has an optocoupler.
Both the SSR and optocoupler have an isolation voltage of 1500 VRMS between the external terminals
and internal camera circuitry. The input is further protected with a serial 250Ω resistor and a
debouncing circuit.
Figure 2: AUX I/O use case example