Installation Manual
Table Of Contents
- Package Contents
- _Toc480133996
- Camera Overview
- General Installation
- _Toc293149143
- _Toc480133997
- _Toc480133998
- _Toc480133999
- _Toc480134000
- _Toc480134001
- _Toc480134002
- _Toc480134003
- _Toc480134004
- Auxiliary I/O Functions
- _Toc480134005
- _Toc317915403
- _Toc317915404
- Camera Power Up
- _Toc480134006
- Camera Discovery, Setup, and Configuration
- Network Protocols
- _Hlt293570828
- _Toc298421343
- _Toc299264241
- _Toc480134007
- _Toc480134008
- Camera Preset Configurations
- _Toc480134009
- _Toc480134010
- _Toc480134011
- _Toc480134012
- General Remote Focus, Pan, Tilt, Zoom
- _Toc480134013
- AV IP Utility Focus/ Pan/ Tilt/ Zoom Tab
- _Toc397515206
- _Toc480134014
- Mounting Templates
- _Toc480134015
- Support
- _Toc480134016
Installation Manual
Page | 32 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com avsales@arecontvision.com
SurroundVideo® Omni G3
Auxiliary Power
If the camera is powered by a separate outside AC or DC power source, run the supplied power
cable through the access hole on the camera housing and connect the power cable to the 2-
position connector on the main camera board. The approximate location of the 2-position
connector is circled below.
NOTE: Cameras using auxiliary power with 802.1x enabled may need to manually power cycle the
camera to reconnect to the network.
CAUTION! Make the connections inside a watertight compartment. Isolate unused power
wires individually.
After connections are made, ensure that the watertight compartment is tightly closed and
cables and conduits are properly sealed to prevent ingress of water.