Installation Manual
Table Of Contents
- Package Contents
- _Toc480133996
- Camera Overview
- General Installation
- _Toc293149143
- _Toc480133997
- _Toc480133998
- _Toc480133999
- _Toc480134000
- _Toc480134001
- _Toc480134002
- _Toc480134003
- _Toc480134004
- Auxiliary I/O Functions
- _Toc480134005
- _Toc317915403
- _Toc317915404
- Camera Power Up
- _Toc480134006
- Camera Discovery, Setup, and Configuration
- Network Protocols
- _Hlt293570828
- _Toc298421343
- _Toc299264241
- _Toc480134007
- _Toc480134008
- Camera Preset Configurations
- _Toc480134009
- _Toc480134010
- _Toc480134011
- _Toc480134012
- General Remote Focus, Pan, Tilt, Zoom
- _Toc480134013
- AV IP Utility Focus/ Pan/ Tilt/ Zoom Tab
- _Toc397515206
- _Toc480134014
- Mounting Templates
- _Toc480134015
- Support
- _Toc480134016
Installation Manual
Page | 41 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com avsales@arecontvision.com
SurroundVideo® Omni G3
3. To individually adjust each camera module, select the “Focus/PTZ” tab.
NOTE: SurroundVideo® Omni G3 cameras are not to be used as traditional high speed PTZ cameras.
The motorized movement of the camera gimbals is meant for setup and configuration only. Movement
of the modules more than one time per day will void the warranty.
NOTE: Module CH2 will not pass the FRONT position shown on the mounting plate. This is to avoid
cable routing problems.
NOTE: Modules will stop moving once they hit the neighbor module during pan movement in either
direction
NOTE: Live video is disabled during pan/tilt adjustment.
NOTE: Additional information regarding the Arecont Vision
®
web interface is found separately in the AV
IP Utility Web Browser Manual via the Arecont Vision website.
Create Custom Preset Configuration
1. In “Preset buttons” section, click “Create Preset 1” or “Create Preset 2”