Installation Manual

Page | 31 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
Auxiliary Power
If the camera is powered by a separate outside DC power source, run the supplied power cable
through the access hole on the camera housing and connect the power cable to the 2-position
connector on the main camera board. The approximate location of the 2-position connector is
circled below.
NOTE: Cameras using auxiliary power with 802.1x enabled may need to manually power cycle the
camera to reconnect to the network.
CAUTION! Make the connections inside a watertight compartment. Isolate unused power
wires individually.