Installation Manual

Page | 32 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
After connections are made, ensure that the watertight compartment is tightly closed and cables and
conduits are properly sealed to prevent ingress of water.
NOTE: A yellow LED on the rear of the camera illuminates after a few seconds.
• The flashing yellow LED indicates that a link to your computer has been established.
• A green LED will blink when the camera has been accessed.
LED
Status
Description
Yellow
Flashing
Link has been established.
Solid
Normal Operation.
Green
Flashing
Camera has been accessed. Normal operation.
Solid
N/A
None
None
No Connection.
NOTE: Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and
with all local codes and authorities having jurisdiction. Wiring should be UL Listed and/or Recognized
wire suitable for the application.
Reset to Factory Default
1. Press and hold the reset button as shown in Figure 1 for 10 seconds and release the reset
button. The camera has been reset to the factory default. If the camera is not connected to
DHCP server, the default IP address is 192.168.0.80
2. Also can reset to factory default via camera web interface or AV IP Utility
NOTE: Additional information regarding the Arecont Vision
®
web interface is found separately in the AV
IP Utility Web Browser Manual via the Arecont Vision website.