Installation Manual

Page | 34 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
Locally Storing Data
The MegaDome
®
UltraHD camera includes a SDHC card slot for onboard storage. To set-up the SD
card features, the Web Interface page or AV 200 can be used.
The camera supports class 10 microSD or microSDHC cards up to 32GB. Not all SD cards are the
same. Arecont Vision highly recommends using SanDisk Extreme Micro SD cards (or an equivalent
substitute) as these cards have been fully tested without issue. The SanDisk Extreme line is better
suited for demanding applications like constant recording. Typical lower grade SD cards are meant for
multimedia applications and will, at times, have questionable quality and reliability.
Recording to the SD card is FIFO (first in first out). The oldest (first) entry is deleted first as new storage
requirements arise. There is no indication when this will happen. Storage time is dependent on a variety
of factors such as SD card size and camera FPS.
SD Recording supports video only. Audio is not supported.
SD Card Set-up
Insert an SD card (user supplied) into the SD card slot until it locks in place. The location of the SD card
slot is located on the main unit. The SD card can only be set-up via the Web Interface or AV200
Software.
Note: Upon insertion or removal of an SD card, the camera must be rebooted.
Note: It is recommended to setup recording time to extend at least 60 seconds past the desired
stopping point to avoid missing critical recorded video.