Installation Manual

ConteraIP

Omni LX RS Installation Manual

4. Remove the conduit plug on the junction box adapter, then connect ¾” NPT conduit to the

junction box adapter.

Reference # Description

1 Remove conduit plug

Connect ¾” NPT conduit to junction box adapter (Recommended:

use of waterproof tape)

NOTE: Use silicon or water pipe seal tape to make sure there is no water leakage between conduit

pipe and junction box adapter.

5. Run the ethernet cable and outside power cable (if necessary) through the rubber gasket which is

supplied, then pass through the Junction Box Adapter and AV-WMJB-W, Wall Mount Adapter.

Ensure the gasket is sealed properly.

6. Attach the Wall Mount Adapter (AV-WMJB-W) to the Pole Mount Adapter (AV-PMA-W) as shown

below

Reference # Description

1 Steel straps with compression screws

AV-WMJB-W wall mount

CORS-CAP-W mount cap

AV-PMA-W pole mount

Apply Teflon waterproof tape to the thread of ¾” NPT pipe to avoid

water leakage

7. Use two Steel Straps which are supplied to attach the Pole Mount Adapter to the pole and tighten

the compression screws.

8. Refer to the Wall Mount section for attaching the camera to the Wall Mount Adapter (AV-WMJB-

W).

9. To configure the camera, refer to the Camera Discovery, Set-up and Configuration section.