Installation Manual

ConteraIP

Omni LX RS Installation Manual

Reference # Description

1 Remove the conduit plug.

Connect ¾” NPT conduit to junction box adapter (ensure to use

the waterproof tape).

NOTE: Use silicon or water pipe seal tape to make sure there is no water leakage between conduit

pipe and junction box adapter.

5. Run the ethernet cable and outside power cable (if necessary) through the rubber gasket which is

supplied, then pass through the Junction Box Adapter and AV-WMJB-W, Wall Mount Adapter.

Ensure the gasket is sealed properly.

6. Attach the Wall Mount Adapter (AV-WMJB-W) to the Corner Mount Adapter (AV-CRMA-W) as

shown below.

Reference # Description

1 Attach corner mount adapter to an exterior 90-degree corner wall

AV-WMJB-W wall mount

CORS-CAP-W mount cap

AV-CRMA-W corner mount adapter

Apply Teflon waterproof tape to the thread of ¾” NPT pipe to avoid

water leakage

7. Use the provided screws or other hardware to attach the Corner Mount Adapter on an exterior 90-

degree corner wall.

8. To attach the camera on the Wall Mount Adapter (AV-WMJB-W), refer to the Wall Mount section.

To configure the camera, refer to the Camera Discovery, Set-up and Configuration section.