Instructions for Use
13
Transmitter Pairing
Pairing is the process of programming the receiver in the Mini Gamma to
recognize the Globally Unique Identier (GUID) code of a single specic
transmitter. If ever you nd that the transmitter does not operate your Mini
Gamma as it should, it may be necessary for you to re-pair the transmitter
and receiver using the following procedure:
• With the transmitter switched OFF, prepare it for pairing by pulling the
throttle stick back to its lowest point. Switch the Stabilization Mode to the
OFF position.
• Connect a fully charged battery to the airplane, place the Mini Gamma
on a level surface where it can remain still and undisturbed by wind, then
power the transmitter ON within 5 seconds of connecting the battery.
Important: Do not move the Mini Gamma during the pairing process.
• The transmitter and Mini Gamma will pair within 8 seconds.
• Check the controls for correct operation.
• If pairing is unsuccessful, unplug the LiPo battery, ensure you have fresh
AA batteries in the transmitter, then repeat the process.
Replacement Parts
AZSA3151 Fuselage
AZSA3152 Wing and tail set
AZSA3153 Wing strut set
AZSA3154 Window decals
AZSA3155 Landing gear
AZSA3156 Spinner
AZSA3157 Propeller 5”
AZSA3158 Pushrod set
AZSA3159 Servo horn set
AZSA3160 Motor and gearbox
AZSA3161 180mAh 3.7V LiPo
AZSA3162 4 in 1 control unit
AZSA3163 2.4GHz transmitter
AZSA3164 3.7V USB charger