User's Manual

Optical Mouse & Optical Mouse Pro
User’s Manual
-------------------------------------------------------------------------------------------------------------------------------
 Introduction
Congratulations on your purchase of the most innovative mouse, which includes the
optical image sensor for superior performance on your PC.
The Optical Mouse/Pro, which is incorporated the revolutionary optical sensor and scrolling
technology is equipped with the following features:
‧ Increasing the accuracy of cursor motion: the optical image sensor records motion on
a surface 1,500 times per-second for pin-point accuracy.
‧ It works on most of surfaces, including wood, plastic, or even your pant leg. No mouse
pad is required.
‧ No parts to clean: A conventional mouse with a rubber ball needs to be cleaned very
often. Instead, the Optical Mouse/Pro detects the motion optically; there is no need for
regular cleaning of mouse parts.
‧ Auto-displaying for incoming e-mails. Works on IE5.0 and up version and Netscape.
The e-mail function only works on USB, PRO version only.
 Hardware Installation
1. Turn off your PC
2. Connect Optical Mouse/Pro (PS/2,6-pin connector) to PS/2 port, or Connect Optical
Mouse/Pro (USB) to USB port.
3. Turn on the PC.
*The limited connection will be supported only based on the type of model you bought.
 Software Installation
1. Un-Install or removing the current mouse driver
Before installing the driver of Optical Mouse/Pro, we suggest that you check if any
other mouse driver installed in your system. If yes, in order not to make conflict,
please un-install or remove that driver before installing the Optical Mouse/Pro driver.
2. Install the Optical Mouse software
a. Insert the Optical Mouse/Pro software diskette into drive A or B.
b. For Window 95/98/2000/NT/ME, choose the “Start” menu, and select “Run”
c. Type “A: SETUP”(or ”B: SETUP”) in the command line, and select “OK’.
d. Follow the instructions on the screen, and RESTART the PC when the installation
is completed.
e. For Pro version: E-mail displaying function will be initialed as well if the driver had
been installed successfully.
Note:
1. The optical Mouse/pro software diskette includes both optical Mouse/Pro driver and application
program. Please follow the above procedure to install both of them. The optical Mouse /pro
application programs will NOT be installed if you install only the driver through the hardware.
2. Because Microsoft Windows NT4.0 does not support USB interface, Please use the PS2 model to
work for window NT4.0.
3. Un-Install the Optical Mouse/Pro
To remove the Optical Mouse/Pro software from your hard disk:
In Windows 95/98/2000/NT/ME) Click the “Start” menu, select “Programs”, and move
to “Wheel Mouse”, then click ”Uninstall icon”.
 Customize Optical Mouse/Pro
With the software provided, eight commonly used tasks can be assigned to the
programmable wheel button.
1. Double click the "Optical Mouse/Pro" icon at the lower right corner of Windows control
panel.
2. Or select “wheel Mouse” from windows.
3. Now the software control panel section will be displayed on the screen.
4. ere are five sections including left/right Button, Pointer, Motion, Wheel, and