User's Guide

ScanBrick® W User Manual
Doc: ARE-016631
Issue: 7.2
Date: Sept 2022
13
3. Host interface paradigma
3.1. Switching ON ScanBrick® W
Every time the ScanBrick® W must be switched ON the procedure described here shall be followed:
• Connect the Ethernet cable to ScanBrick® W using the connector as specified in Section 2.2;
• Connect the other head of the Ethernet cable to a PC network interface (notice that the
connection might be either direct or through a LAN);
• Power ON the system by providing the required electrical interface (12V) to the power supply
connector specified in Section 2.2.
3.2. ScanBrick® W startup sequence
Every time the ScanBrick® W is switched ON the startup steps sketched in Fig.4 are performed.
Each step is described in detail in the following.
Fig.4 ScanBrick® W startup steps.
Power ON
This state immediately follows the feed of power supply to the system. The processing environment
is initialized and just the Network task is activated. The Network task is launched with the default
factory network settings. Typical example of factory network settings is reported in Tab.4.
Tab.4 ScanBrick® W – example of factory network settings