User's Guide

ScanBrick® W User Manual
Doc: ARE-016631
Issue: 7.2
Date: Sept 2022
19
to connect with this IP address. If this button is pressed, the Device Connection Panel is
updated as in Fig.8.
- Press Select MAC button: in this case the Level Metering application will always work with
the radar device identified by this MAC address. In case of connection break down, the
application will try to reconnect with this MAC address, no matter of the IP which is currently
assigned to the device. If this button is pressed, the Device Connection Panel is updated as
in Fig.8.
Fig.8 Device Selection Panel
The button Browse is useful to select the folder of the filesystem where to store all the data, logs
and results of the application. LevelMetetrGUI application will set the content of the folder as shown
in Fig.9. The results of the application processing are stored in separated folders, one for each
working day (see the folder 2019.10.01 in Fig.9). In the Debug folder, for each working device, these
data are stored:
- Last set radar configuration;
- Log files;
- Raw Data (i.e. data produced by the radar and not processed);
- Some processing results.
To reduce the amount of stored data, it is necessary to uncheck the Enable Debug check box: in
such a way, the logs only will be saved in the Debug folder.