User's Guide

ScanBrick® W User Manual
Doc: ARE-016631
Issue: 7.2
Date: Sept 2022
21
- TryConnect button: by clicking this button, a cycle of period connection attempts is started.
Each time the device disconnected, automatically the application will try to reconnect the
system. When a connection attempt succeeds the Connection State of the Level Metering
application (see Fig.14) becomes CONNECTED, elsewhere it is DISCONNECTED.
- Disconnect button: by clicking this button the periodic connection attempts are stopped and
the application disconnects from the radar (the Connection State is forced to
DISCONNECTED in Fig.14).
- Maintenance button: by clicking this button, the radar system maintenance window can be
accessed (see Section 4.3). This button can be clicked only if TryConnect button has not
been previously clicked (the system must be disconnected).
Configuration
Before starting a data acquisition session, it is necessary to configure both the acquisition and the
data processing, using the panel in Fig.12.
Fig.12 Configuration Panels
To configure the acquisition, use the Acquisition Configuration panel: