User's Guide

ScanBrick® W User Manual
Doc: ARE-016631
Issue: 7.2
Date: Sept 2022
28
NOTE: when the maintenance windows is closed, the system will be automatically disconnected.
Fig.18 System Maintenance Connection Panel
Finally, clicking the Get Address button, it is possible to get the MAC address of the selected device
(or the IP address if the device has been selected using the MACaddress).
Connection Mode
Using the panel in Fig.19 it is possible to get the current Connection Mode of the radar (i.e. the way
by with the radar configure its network board, once it exits from the Recovery State, as explained in
3.2). It is also possible to update such a mode.
The possible connection modes are:
1. FACTORY_IP: when exiting the Recovery State, the radar will configure its network board
using a static IP address, hard coded in its non-volatile memory. This static IP configuration
is set by the producer when the radar is manufactured.
2. STATIC_IP: when exiting the Recovery State, the radar will configure its network board using
a static IP address, configurable by the user (Fig.20).
3. DYNAMIC_IP: when exiting the Recovery State, the radar will configure its network board
using an IP address gotten from a DHCP server.
NOTE: it is necessary to restart the device to have the Connection Mode changes to become
effective.