User's Guide

ScanBrick® W User Manual

Doc: ARE-016631

Issue: 7.2

Date: Sept 2022

Fig.19 Connection Mode Panel

System Network Configuration

Using the panel in Fig.20 it is possible to read and update the network static configuration of the

radar, i.e. IP address, Network mask and Gateway address. This network static configuration is the

one used when STATIC_IP mode is set as Connection Mode for the radar.

Fig.20 System Network Static Configuration Panel

NOTE: current IP address of the radar (shown in the panel of Fig.18), should not match the static IP

address get from the radar in Fig.20. For example, if the currently set Connection Mode (Fig.19) is

DYNAMIC_IP, the current IP address of the radar is obtained by a DHCP server and hence it almost

certainly does not match the statically configured IP address.

NOTE: it is necessary to restart the device to have the Network Static Settings changes to become

effective.

Keep Alive Period Management

Using the panel in Fig.21 it is possible to read and update the period of the keep alive message,

expressed as millimeters. This is a message periodically sent from the radar to the host, to check if

the connection is still alive. The period of the keep alive message is both the duration between two

consecutive message transmissions and the time radar waits for an answer from the host.