User guide

ARETE POP User Guide
21 / 22
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution
Modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
CE
This device is in compliance with the essential requirements and other relevant provisions of directive
1999/5/EC.
TELEC
本機器は、電波法第38条の24第1項の規定に基づく認証を行ったものであることを証する。
KC
본 기자재는 전파법 제58조의2 제2항에 따라 인증되었습니다. 적합성평가표시 정보는 다음과 같
습니다. 적합성평가를 받은 자의상호: 주식회사 파이칩스. 기자재의 명칭 및 모델명: RFID/USN용
무선기기(900MHz 대역사용기기) / A100-K. 제조년월: 2013. 인증번호: MSIP-CRM-PHY-A100K. 제
조자: 주식회사 파이칩스. 제조국가: 대한민국
4.4 Troubleshooting
Q: What should I do if I fail to turn on ARETE POP?
A: First, check the batter power status.
Second, recharge for a certain amount of time and try again.
If you fail to turn it on again, please contact where you buy it.
Third, if red LED is blinking in standby status, it is battery failure.
Please contact where you buy it.
Q: What should I do if ARETE POP gets wet?
A: Dry it first.
If it does not working properly after being dried, then contact where you buy it.
Q: What should I do if I fail to read tag?
A: Turn volume up to 100%. Check power status of A100.
Third, it is possible to fail to read tag due to interference if other RFID readers are being used
in the same place.
Q: A100 beeps when it is reading tags. But EPC is not showing in the list.
A: Please touch diagnostic button in information tab. Wait for diagnostic process done.
Send generated files in yourPhone/sdcard/AUDIOTEST folder to [e-mail].
4.5 Disposal and Recycling
You must dispose of ARETE POP properly according to your local laws and regulations.
Because electronic components and a battery are included in the ARETE POP