User manual

User manual BS1000 LAN base station 2 / 18 July 5 2010
1. On/Off switch 5 LAN connector
2. Red LED 6. USB connector
3. Blue LED 7. DC connector
4. Green LED
LED functions:
Red LED LED is on when the BS-1000 is powered on.
Blue LED Blinks when the BS-1000 receives sensor data
Green LED
– Off: network and flash memory storage are not active
– On: network not active, flash storage active,
– Blinks short on and long off: network active, no flash storage
– Blinks long on and short off: network active, flash storage active
Software Installation
Prior to using the BS1000 via USB, you have to install the supplied software on your PC.
Insert the supplied CD-ROM into the CD drive of your PC. After insertion the
installation wizard will appear. If the automatic set up has been disabled in your
Windows software, you can activate the window by opening the Explorer file, go to the
CD drive and double-click on the default.htm file.
Select your language on the installation screen and then select the installation option.
Follow the instructions on the screen.
Installation of the receiver
Once you have installed the software and connected the BS1000 to the 5V power supply,
you can connect the receiver module (BS1000) to your computer via the supplied USB
lead. Windows will now start installing the required RF_USB driver. Depending on your
Windows version, the installation process may slightly vary: