Operator`s manual
67
SECTION 11
ACCESSORY INFORMATION
11.20 ROLL BAR ACCESSORY (Part No. 648-15)
The roll bar is designed for use on all Argo 6 x 6 models. The
roll bar provides some roll over protection and lap belts for
the driver and front seat passenger.
When the Roll Bar Kit is installed, ALWAYS wear seat
belts when operating the vehicle on land. REMOVE seat
belts when entering water.
Maximum total vehicle weight must not exceed 1465 lbs.
or 665 kg. which means 2 people and 100 lbs. or 46 kg.
of cargo in the vehicle.
Never attach anything to the Roll Bar other than Ontario
Drive & Gear 648-15 Roll Bar specic accessories.
The Roll Bar reduces vehicle stability. Always use com-
mon sense when traveling over rough terrain.
The Roll Bar is designed to reduce the chance of injury.
DO NOT rely on it to protect the vehicle occupants from
irresponsible driving.
The Roll Bar could come in contact with tree branches.
Falling branches or vehicle upset could occur. Use
extreme caution when traveling on narrow tree lined
trails.
DO NOT use the Roll Bar as an attachment point for
towing or winching.
Check the torque of the Roll Bar nuts and bolts annu-
ally and replace any parts that are damaged. When the
Roll Bar is installed, never carry more than two people
in the Argo.
Replace worn or damaged seat belt straps and buck-
les.
Failure to comply with the above could result in per-
sonal injury or death.
11.21 12V ACCESSORY OUTLET ACCESSORY (Part
No. 633-25)
The 12V Accessory Outlet Kit contains a 12V outlet, wire
harness complete with in-line fuse holder & fuse, and the
necessary hardware to mount the outlet in the upper body of
any Argo model. When mounting the outlet, be sure to select
an area within reach for the wire harness. The wire harness
gets connected directly to the battery terminals so any mount-
ing location chosen, must allow the harness to reach both the
outlet and the battery. When mounting, be sure that the wire
harness is securely clipped into place and not left dangling
near moving parts within the engine compartment.
Because the outlet is wired directly to the battery, it is
constantly "live," even without the key turned on. Exces-
sive use will run down the battery.
This outlet is NOT designed to support nor should it be
used as a cigarette lighter socket.
11.22 BRUSHGUARD ACCESSORY (Part Nos. 642-20
& 642-40)
The Brushguard Kit protects the winch and headlights from
damage by the brush encountered along the trail. It features
an integrated tow hook. Installation of mounting kit or power
winch is required.