EN ELECTRIC HEATER WITH CARBON FIBER HEATING ELEMENTS OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference.
GENERAL SAFETY INFORMATION Use this carbon fiber heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. Ensure that the mains power complies with the voltage specified on the carbon fiber heater data plate (220-240V~/50Hz).
WARNING: In order to avoid hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through and external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. WARNING: do not use the fan heater with a controller or any other external device that activates the appliance automatically, as there may be a risk of fire if the fan heater is covered or incorrectly positioned.
The most common cause of overheating is the build-up of dust in the appliance. Remove dust deposits by unplugging the appliance and cleaning the air outlets and grilles with the aid of a vacuum cleaner. Do not use abrasive detergents for cleaning this appliance. Clean the appliance with the aid of a damp (not wet) cloth rinsed in hot soapy water. Always remove the plug from the mains socket before cleaning.
Do not operate the carbon fiber heater in close proximity to bathtubs, showers, washbasins or pools. Do not position the carbon fiber heater below a socket outlet. Do not operate the appliance outdoors. Upon initial start-up, the carbon fiber heater may emit a slight, harmless smell. This smell is a normal effect of the initial heating up of the internal heating elements, and should not recur later on. WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER.
DESCRIPTION OF PARTS 4 2 9 1 1 8 7 3 6 5 On/off selection knob Swing button Carbon fiber heating elements Handle 5. Base 1. 2. 3. 4. 6. 7. 8. 9. Anti tip device Fixing screws Fairlead Cable reel HOW TO USE THE CARBON FIBER HEATER Connect the power cord to a suitable electric socket (220-240V~/50Hz). Place the On/off and selection knob in the desired position: ECO (500 W) or COMFORT (1000 W).
OVERHEATING SAFETY DEVICE In case of overheating the safety cut out protecting the heating element will automatically switch off the appliance. In this case the appliance stops working. If this happens: switch off the heater; remove the causes of abnormal operation or overheating (i.e. obstacles in front of air inlet or air outlet grille, abnormal accumulations of dusts inside the appliance); let the heater cool down for 15/20 minutes; switch on again the heater and verify the correct operation.
