User Manual

Brake System Argo Service Manual
BR-12
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Installing the Service Brake Pads (HDi)
NOTE
Before installing new pads, use brake cleaner on components before re-assembly to remove
oil and other contaminants.
CAUTION
Ensure the brake pads are NOT installed backwards. The pad side must be installed
towards the brake disc. The brake pads utilize a black coloured anti-squeal coating
on the opposite side of the pad which could be mistaken for the pad surface.
1. Place Service Brake Pads into caliper and spread apart while slipping over the Service
Brake Disc. Apply Blue LOCTITE 243 to the threads of the shoulder bolts and re-
mount the caliper back to the brackets. Torque to specications.
Brake Pad Bedding In Process
Bedding in of the service brakes is recommended by the brake pad manufacturer to obtain
maximum performance and wear from the brake pads. Each time a new set of pads is re-
placed, the following procedure is advised.
1. Ensure that the service brake system has been bled to provide maximum braking.
2. For this procedure select an area that is open and at, such as an empty parking lot.
3. Drive the Argo at a speed of approximately 20kph. While continuing to apply throttle,
gradually apply the service brake, slowing your speed down to 10kph, then release the
brake and accelerate back to 20kph. Repeat a total of 10 times. Do not wait between
cycles to let brakes cool. Do not bring the Argo to a full stop (unless required for
safety reasons).
IMPORTANT
The brakes may smell and some smoke could be present. Bringing the Argo, to a full
stop when the brakes are hot may cause the brake pad to imprint itself on the rotor.
If this happens it will cause vibration and poor brake performance.
CAUTION
As the brake components will be extremely hot at this point.