User Manual
Argo Service Manual Brake System
BR-19
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
NOTE
Knott Calipers are secured together by four (4)
Hex Head Cap Screws, Eight (8) Flat Washers,
and four (4) Fin Hex Nuts. Photo A
8. Reinstall the Socket Head Cap Screws (Gremica
Calipers) which hold the caliper assembly togeth-
er. Use blue LOCTITE 243 on the threads of the
fasteners. Torque the bolts to the specied torque.
Photo 18
9. Place the check ball and bleed screw back
into the threaded mount of the caliper cast-
ing. Photo 19. Cap with the rubber plug.
Photo A
Photo 18 Photo 19
10. Slide the brake pads into the calipers and secure with 2 new cotter pins.
Hydraulic Brake Caliper Installation
NOTE
Before installing new calipers, use brake cleaner on components before re-assembly to
remove oil and other contaminants.
11. Remount the caliper to the transmission by aligning the access hole in the brake disc
with that of the threaded mounting boss on the transmission. LOCTITE the threads of
the 2 socket head mounting bolts with blue LOCTITE 243 and secure the caliper (with
the two (2) at washers or lockwashers) to the transmission. Photos 21 & 22. Torque
to specications.