User Manual

Brake System Argo Service Manual
BR-22
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Photo 24 Photo 25
Photo 26 Photo 27
Disassembling the Master Cylinder (Gremica - typically black in colour)
1. Perform the servicing procedure, Master Cylinder Removal
2. Pull the piston and compression spring from the master cylinder. Photo 27
CAUTION
Do not use a gripping tool to pull out the piston as this will scratch or damage the
surface. Use ngers only to pull out the piston. If this does not work, reinstall gasket
and cylinder cover and blow compressed air (Low Pressure 20 psi or less) through the
uid inlet hole.
3. Slide the primary and secondary seals off the piston. Discard the old seals.
CAUTION
Do not scratch the piston when removing the seals.