User Manual
Brake System Argo Service Manual
BR-24
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Primary Seal
Secondary Seal
Photo 28 Photo 29
2. Install the compression spring to the brake plunger. Photo 29
3. Install the spring & plunger into the piston bore. Slide the end with the primary seal in
rst. Photo 30
Photo 30 Photo 31
4. Temporarily install the cover and gasket onto the master cylinder reservoir.
Master Cylinder Installation
1. Line up the holes in the mounting bracket with those of the master cylinder and insert
the 2 mounting bolts. Photo 31
2. Reinstall the nylon locknuts and tighten to anchor the master cylinders into position.
3. Reconnect the brake lines to the master cylinders. Always use new copper washer
seals on the banjo bolts. Torque to specications.
4. Rell the master cylinders using DOT 5 Brake Fluid. Use of other types of brake
uids or combining different types of brake uids, may result in damage to steering/
braking components or seriously impair the way in which the vehicle performs.
5. Perform the servicing procedure, Bleeding the Hydraulic Brake System below.