User Manual

Argo Service Manual Brake System
BR-25
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Bleeding the Hydraulic Brake System (HDi)
IMPORTANT
The position at which the brake calipers are mounted on both 34-100 and 34-200
transmissions is less than ideal for optimum bleeding and purging of air from the
system. In order to bleed and purge all air from the brake system successfully, the
calipers should be removed and remounted vertically. Ensure also master cylin-
ders are level. This may require raising the back end of the vehicle slightly. Please
refer to the following procedure to ensure a properly bled brake system.
1. Perform the servicing procedures, Re-
move Hydraulic Brake Caliper, (re-
move drive belt & driven clutch for
left hand brake caliper).
2. Remove the brake disc fastener secur-
ing the brake disc to the output shaft.
Photo 36
3. Reattach the caliper to the brake disc at
the lower mounting hole (with the previ-
ously removed fastener) so that the cali-
per is now in the upright position. Photo
37 & 38
Photo 36
Left Side Caliper
Photo 37 Photo 38
4. Remove and remount the right hand brake caliper as described previously for the left
hand brake caliper. Photo 39 & 40