User Manual

Brake System Argo Service Manual
BR-30
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
CAUTION
Regular inspection of the brake uid is very important. Low uid levels can cause
a reduction or loss in braking ability; high uid levels, or brake uid contaminated
with oil, dirt, or water, can damage the seals or other component parts of the hydrau-
lic brake system.
Inspecting the Brake Fluid Condition
Maintenance Schedule- Inspect every 50 hours of vehicle operation.
Use only Dot 5 silicon brake uid. Other brake uids may not be compatible with ARGO
brake components and operating temperatures.
1. Locate the master cylinder in the engine compartment. It is located at the top of the
transmission.
NOTE
To access the master cylinder cover, remove the hood assembly. You can then remove the
cover screws with a screwdriver
2. Clean the casing and lid of the master cylinder. This will prevent dirt or other contami-
nants from entering the reservoir.
3. Using a screwdriver, unfasten the cover screws and remove the cylinder cover and
gasket.
Inspect the condition of the brake uid and replace if:
 the uid appears cloudy
 the uid appears discoloured
 the uid contains particles of dirt, rust, water, or other contaminants
 the level is below the viewing window
If any of these conditions are noted, perform the servicing procedure, Changing the
Brake Fluid below.
Changing the Brake Fluid (Steering Brakes)
CAUTION
Clean the master cylinder casing and ttings. This will prevent dirt from contaminat-
ing the brake system. Contaminants in the brake uid can damage components or
cause premature wear to them. This will result in a loss of braking effectiveness.