User Manual

Brake System Argo Service Manual
BR-32
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Disassembling the Service Brake Calipers
Photo 49
1. Remove the service brake master cyl-
inder cover (located on the left hand
steering bar) and remove the uid from
the bowl. Use a vacuum type pump.
Photo 49
2. Loosen the brake line banjo bolt at the
service brake caliper. Photo 50
3. Locate and remove the two (2) fasten-
ers securing the Service Brake Caliper
to the mounting Bracket. Photo 51
Cover
Photo 50 Photo 51
4. Completely disconnect the brake line from the service brake caliper and remove the
caliper to a clean work surface. Set the brake pads aside.
5. Remove one of the bleeder screws from the caliper. Photo 52
6. Using an air nozzle, SLOWLY apply some compressed air to the empty bleeder screw
area while plugging the open brake line hole with a large at washer under thumb.
Photo 53. Slowly force air to push the piston from the piston cavity.