User Manual

Argo Service Manual Brake System
BR-35
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
12. Thoroughly inspect all the components. Replace any worn, cracked, broken or missing
parts.
13. Inspect piston chamber for any pitting, scratching, scarring or rust. Replace piston
with new one that comes with kit or the entire caliper assembly if necessary.
Re-Assembling the Service Brake Calipers
1. Lubricate all component parts with clean fresh Dot 5 Silicon Brake Fluid.
2. Install kit supplied rubber O-Rings into each of the two mounting hole areas on the half
caliper. Photo 50
O-Ring
Photo 50 Photo 51
3. Assemble the piston to the rubber boot/seal by pushing it from the bottom up. Rubber
O-Ring is at the bottom. Photo 51
4. Once the piston is pushed through the rubber boot, collapse the boot around the piston.
Photo 52
O -Ring to Back
Photo 52 Photo 53
5. Lubricate both piston and boot/seal with fresh Dot 5 brake uid. Push into the cali-
per bore. The piston is a tight tolerance with the bore. Ensure you push square and
evenly into the bore. DO NOT FORCE! You should be able to install by hand only.
Photo 53.