User Manual
Brake System Argo Service Manual
BR-40
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
3. Disconnect the hydraulic hose from the master cylinder.
4. Replace the hose.
5. Reconnect the hydraulic hose to the master cylinder. Make sure both copper washer
seals have been replaced with new ones at the banjo bolts. Torque to specications.
6. Perform the servicing procedure, Bleeding the Hydraulic Brake System.
Brake Disc Inspection
Maintenance Schedule - Inspect every 50 hrs. of vehicle operation.
IMPORTANT
Badly worn brake pads, or abnormal use of the vehicle, can cause serious damage to
the brake discs. Inspect the brake discs for the condition listed in the chart below,
and perform the recommended servicing procedures.
Always refer to the PARTS MANUAL that corresponds to the specic model and
serial number indicated on the serial tag plate of your vehicle. This is essential to
locating and ordering the correct components that were used during that particular
manufacturing period.
Brake Disc Condition Corrective Action Servicing Procedure
Rust or pitting Replace Immediately 1. Brake Disc Removal
Bends or cracks 2. Brake Disc Installation
Scratches or scoring
Broken or worn
sprocket teeth
Glazing Clean 1. Brake Disc Removal
Oil or grease 2. Brake Disc Installation
contamination
Removing a Brake Disc (Models with 34-100 Transmission)
1. Perform the servicing procedure, Removing the Front Floor Pan
2. Perform the servicing procedure, Removing the Firewall.
3. Raise vehicle off the ground to rotate the tires. Rotate tires until brake disc access hole
is aligned with the socket head fasteners of the brake caliper. Photo 62 & 63