User Manual

Brake System Argo Service Manual
BR-72
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
5. Remove the Lower Handle Bar Clamp
from the steering shaft. Photo 165
IMPORTANT
Be aware of the small key(s) installed into
the steering shaft and ensure they are in-
stalled when reassembling the steering
system.
6. Disconnect the hand brake lever cable at
the steering arms.
Photo 165
7. Apply pressure to the left hand side plunger pin by pushing on the steering arm with
the palm of your hand and insert a shim between the locking collar and the welded tab
stop. Photo 166. Repeat on the right hand side master cylinder. Following this pro-
cedure will ensure that there is no interference between the plunger pins and steering
arms, when sliding the shaft from the steering column.
8. Slip the Steering Shaft from the Steering Column Assembly. Photo 167
Photo 166 Photo 167
Disassembling the Steering Shaft - Avenger Models Only - Prior to 22441
i. Place the Steering Shaft on a clean work bench and remove the 4 roll pins. Photo 168
Slide each steering arm and centering spring from the shaft.
NOTE
(1) Retaining Ring is located between the (2) Steering Arms.