User Manual

Argo Service Manual Brake System
BR-75
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
iii. Next, install a Retaining Ring to the machined groove on the Steering Shaft. This re-
taining ring will be located between the 2 steering arms.
iv. Install the second steering arm and last spring pin. Photo 178. Orient as in Photo 179
Photo 178 Photo 179
9. Apply some axle grease to the length of the Steering Shaft, Photo ST-180, and insert it
from the bottom up, into the Steering Column Assembly with the small keyway facing
towards you. Photo 181
Photo 180 Photo 181
10. Place the key to the end of the Steering Shaft. Photo 182. Vehicles manufactured
from serial numbers 23535 utilize 2 keyways and 2 keys.
11. Align the keyway(s) of the Lower Handle Bar Clamp with that of the previously in-
stalled key(s) and assemble to the Steering Shaft. Photos 183 & 184