EN HALOGEN HEATER OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference.
GENERAL SAFETY INFORMATION Use this halogen heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. Ensure that the mains power complies with the voltage specified on the halogen heater data plate (220-240V~50Hz). This product is not a toy. Children of less than 3 years should be kept away unless continuously supervised.
Do not place anything on the appliance, use the appliance to dry clothing. Use the appliance in a well-ventilated area. Avoid placing fingers or foreign objects in the air inlet/outlet grilles, as this may lead to electric shock or fire and may damage the appliance. To avoid the risk of fire, do not block the grilles or tamper with them in any way while the halogen heater operates. Do not use the appliance if the cord or plug are damaged.
Do not connect the appliance to the mains power before it has been properly assembled and positioned. Do not run the cord under carpets. Do not cover the cord with blankets, carpets or similar materials. Place the cord far away from busy areas or where it cannot be accidentally pulled-out. Do not operate the halogen heater in close proximity to bathtubs, showers, washbasins or pools. Do not position the halogen heater below a socket outlet. Do not operate the appliance outdoors.
DESCRIPTION OF PARTS 4 2 8 7 1 3 6 5 1. 2. 3. 4. 5. On/off selection knob Swing button Halogen lamps Handle Base 6. Anti tip device 7. Fixing screws 8. Fairlead HOW TO USE THE HALOGEN HEATER Connect the power cord to a suitable electric socket (220-240V~/50Hz). Place the On/off and selection knob in the desired position: ECO (500 W) or COMFORT (1000 W). SWING button When the appliance is operating, touch the button to make the appliance swing automatically, shifting the air flow from left to right.
OVERHEATING SAFETY DEVICE In case of overheating the safety cut out protecting the heating element will automatically switch off the appliance. In this case the appliance stops working. If this happens: switch off the heater; remove the causes of abnormal operation or overheating (i.e. obstacles in front of air inlet or air outlet grille, abnormal accumulations of dusts inside the appliance); let the heater cool down for 15/20 minutes; switch on again the heater and verify the correct operation.