EN DEHUMIDIFIER OPERATING INSTRUCTIONS Read the instructions carefully before operating or servicing the dehumidifier. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Keep these instructions in a safe place for future reference.
GENERAL OPERATING AND SAFETY INSTRUCTIONS This appliance is a highly efficient dehumidifier, designed for domestic use only! Use this dehumidifier only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or malfunctions. The unit contains refrigerant; keep it vertical at all times. Once you have opened the unit, keep it vertical to allow the refrigerant to stabilise and wait two hours before operating it.
can cause fires or electric shock. If the power cord is damaged, it must be replaced by a service centre. Do not place heavy objects on top of the appliance. To prevent water spills, empty the water tank before moving the appliance. Do not tilt the dehumidifier onto one side or turn it upside down, as the water which runs out could damage the appliance. Do not operate the unit on unstable or sloping surfaces: water leaks can cause it to malfunction or cause excessive vibration and running noise.
DESCRIPTION OF PARTS (2) FRONT VIEW (1) (4) (3) (5) REAR VIEW 1) CONTROL PANEL 2) CARRY HANDLES 3) DEHUMIDIFIED AIR OUTLET 4) FRONT PANEL 5) WATER TANK; CAN BE REMOVED FOR EMPTYING 6) CONTROL PANEL 7) REAR PANEL WITH AIR FILTER 8) HATCH FOR CONTINUOUS CONDENSATE DRAINAGE HOLE (6) (7) (8) OPERATING INSTRUCTIONS APPLIANCE START-UP Place the product on a flat and stable heat-resistant surface, at least 1 metre away from flammable or heat-sensitive materials and 50 cm away from walls or
If, after following the appliance startup instructions, the dehumidifier does not start and the stand-by (POWER) led does not come on, or if the dehumidifier stops for no reason, make sure the plug and power cord are in good working order. After doing so, wait for 10 minutes and then restart the appliance. If the dehumidifier still does not start after 10 minutes, or if either the power cord or plug are damaged, switch off the appliance and contact an after-sales service centre.
CONTROL PANEL TIMER LED LOW-MEDIUM-HIGH FAN SPEED LED TANK FULL LED CONTINUOUS OPERATION STAND-BY LED CLEAN FILTER LED 1. ON/OFF BUTTON Press this button to turn the dehumidifier on and off. 2. FILTER BUTTON: After 250 hours of operation, the FILTER RESET led turns on to indicate that it is time to clean the filter. Take the filter out and clean it. Then press the FILTER button. 3.
CLEANING THE WATER TANK We advise removing the tank once every few weeks to prevent mould and bacteria forming on it. Fill the tank with clean water a small amount of detergent; swill the water around in it, then it out and rinse it thoroughly. CLEANING THE AIR FILTER The filter is designed to remove dust or dirt from the air. If the filter is clogged by dust, electricity consumption will be higher than normal. For most effective dehumidification, clean the filter every 250 hours of operation.
