Operation Manual

13
EG
HOW TO ACCESS THE WIRING CONNECTIONS
Remove the front panel in the same way of the bottom part (there are no screw to be removed and no wire to be
disconnected).
After you removed the front panel you will see the tank.
In the bottom right part, you will see the cover of electrical connections.
THE FRONT PANEL AND THE COVER OF ELECTRICAL CONNECTIONS MUST BE FASTENED SECURELY DURING
OPERATION OF THE UNIT.
General
• The acceptable voltage variation is: ± 10% during operation.
• The electrical connection conduits must be fixed.
• Class 1 unit.
Power supply and signal cables connection
Emix Tank must always be connected to the electrical power supply in a separate manner compared to the connection
of the outdoor unit, using only the bipolar shielded cable as all the other indoor units.
The power supply must come from an isolation and electric protection device (not supplied) in accordance with existing
regulations.
The installation must be protected by a double-pole circuit-breaker (not included).
ELECTRICAL CONNECTIONS
HOW TO REMOVE THE COVER OF ELECTRICAL CONNECTIONS
Unscrew the fixing screw.
Pull the cover and remove it.
NOTE