EN CERAMIC TOWER FAN HEATER OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance operations. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Store these instructions in a safe place for future reference.
GENERAL SAFETY INFORMATION Use this fan heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. Make sure that the type of mains power complies with the electrical requirements of the fan heater (220-240V~ /50Hz).
Keep flammable materials, such as furniture, cushions, blankets, paper, cloths, curtains and suchlike at least 1 m away from the front, sides and back. Disconnect the mains power when the appliance is not in use or during cleaning. Avoid using the fan heater in dusty environments or in the presence of flammable vapours (e.g. in workshops or garages). Do not place anything on the product; avoid placing wet garments on the fan heater. Use the heater in a well-ventilated area.
WARNING: AVOID COVERING THE FAN HEATER TO PREVENT IT FROM OVERHEATING. The symbol below signals the above warning: The fan heater may cause the risk of fire if, while in operation, is covered by or comes into contact with inflammable material including curtains, drapery, blankets, etc. KEEP THE FAN HEATER AWAY FROM THESE MATERIALS. Do not connect the fan heater to the power supply until it has been correctly assembled or positioned. Do not run the cord under carpets.
In the event of any anomalies (abnormal noise, or a strange smell), immediately turn off the appliance; do not attempt to repair it, and take it to your local service centre. DESCRIPTION OF PARTS 1. Controls 2. LED display 3. Front panel 4. Hot air outlet grille 5. Swinging base 6. Air intake grille with filter 7. On/off switch 8. Remote control Front view Side view Rear view HOW TO USE THE FAN HEATER Set up the fan heater in a vertical position on a level and stable surface.
ECO power mode – energy saving: The default temperature is 20° C. Below 18° C, the appliance runs at high power. Between 18° C and 20° C, the appliance runs at low power. After 20° C, the appliance goes into standby mode. Your settings will be stored even after switching off the appliance and after a power cut. REMOTE CONTROL CAUTION: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE OPERATIONS.
MAINTENANCE AND STORAGE CAUTION: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE OPERATIONS. IMPORTANT: DO NOT SUBMERGE THE FAN HEATER IN WATER Cleaning the outside surface of the appliance Use a soft cloth to remove any dust from the fan heater. If the fan heater is excessively dirty, use a soft cloth dampened with water and neutral detergent at a temperature below 50°C. Leave the fan heater to dry completely before using it again. Do not use corrosive detergents or solvents such as petrol.