Operation Manual

3
GB
• This apparatus must be installed by a qualified technician and in compliance with the
instructions provided.
• Prior to installation, check that the installation's mains voltage corresponds to that indicated
on the rating plate.
1 - INSTALLATION LOCATION
WARNING
• Avoid:
To protect the unit from corrosion, avoid installing the outdoor unit in a location where there is
a risk of it being sprayed with seawater or in an aggressive or sulphurous environment (for
example, near a hotspring).
• The indoor unit must be installed in a frost protection
location.
• Do not install the indoor unit in an area where gaseous emanations
or flammable gases may be present, or in a very humid location
such as a laundry room.
• Do not install the indoor unit in a location containing elements that
release an excessive amount of heat.
• Do not store objects near the outdoor unit so as not to disrupt good
airflow around the exchanger.
CAUTION
• To warm up the system, the power mains must be turned on at leats
five (5) hours before operation. Leave the power mains ON unless
you will not be using this appliance for an extended period.
1. All cables and their installation must comply with current standards and regulations. For
further details, consult your installer.
2. All elements must be properly grounded.
3. The electrical connections must be performed by a qualified technician.
2 - ELECTRICAL REQUIREMENTS
• Read this Instruction Manual carefully before using the apparatus. If you still have any
difficulties or problems, consult your dealer for help.
• The apparatus is designed to give you comfortable room conditions. Use this only for
its intended purpose as described in this Instruction Manual.
3 - SAFETY INSTRUCTIONS
10 11 530_GB_01.qxd 15/02/10 14:00 Page 3