EN ELECTRIC CONVECTOR HEATER MINIMAL IP24 OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference.
GENERAL SAFETY INFORMATION Use this convector only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. This convector is designed for domestic use. It must not be used for commercial or industrial purposes. Ensure that the mains voltage complies with that indicated on the convector data plate (220-240V/50Hz).
automatically, as there may be a risk of fire if the fan heater is covered or incorrectly positioned. The appliance is equipped with an IP24 degree of protection and can be used in private bathrooms in zone 2. The convector must not be touched by people that use bath tubs and showers. Disconnect the mains power when the appliance is not used or for cleaning operations. To disconnect the convector, set the selector to 0 and remove the plug from the socket. Pull on the plug only. Do not pull the cord.
Do not immerse the cord, plug or any other element of the panel in water or other liquids. Do not touch the plug or convector with wet hands. Avoid using the convector in dusty environments or in the presence of flammable vapors (e.g. in workshops or garages). Do not place the convector above or near another heat source. WARNING: AVOID COVERING THE CONVECTOR TO PREVENT IT FROM OVERHEATING.
Do not allow the electric cord to touch the metal structure of the convector when it is hot or in operation, in order to avoid the high temperatures ruining the cord. Do not operate the convector outdoors. Do not use the convector in front of or near an open window. WARNING: do not use the convector with an external controller or any other external device that activates the convector automatically, as there may be a risk of fire if the convector is covered or incorrectly positioned.
DESCRIPTION OF PARTS 2 3 1 4 5 1. Power switch 2. Control panel 3. Front panel 4. Cable 5. Foot HOW TO INSTALL THE APPLIANCE The convector can be used on the floor, after assembling the feet, or alternatively it can be wall-mounted using the specific accessories supplied. MONTARE I PIEDINI IN DOTAZIONE A. Floor portable using: how to assemble the feet supplied The convector is packed without feet. These must therefore be assembled before using the appliance.
2. 3. 4. By supporting the bracket onto the wall, mark on the wall with a pencil the points where it is necessary to make the holes in order to insert the Fishers. Observe the minimum distances from the walls. Place the heater into suitable position ensuing that the holes align with bracket and drill holes in the wall and insert the Fishers. Secure the bracket to the wall and insert the screws supplied. Tighten the screws at the top of the convector firmly.
REMOTE CONTROL 1 1. 2. 3. 4. 5. 2 4 3 5 ON/OFF button MODE button TEMPERATURE button TIMER button CHILD LOCK button CHILD LOCK button Press the CHILD LOCK button, the heater is locked and it can be switched on. Press this button again, the heater is unlocked. The remote control uses Lithium/Manganese button cells, model no. CR2025-3V, compliant with Battery Directive no. 2006/66/CE (supplied with the remote control).
MAINTENANCE AND STORAGE ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE. IMPORTANT: DO NOT SUBMERGE THE CONVECTOR IN WATER. Cleaning the outside surface of the appliance Turn the switch off and unplug before carrying out any maintenance work or moving the appliance. Use a soft cloth to remove any dust from the convector. If the convector is excessively dirty, use a soft cloth moistened with water and a mild detergent at a temperature lower than 50°C. Let the convector dry completely before use.